How to turn an earring into a charm and how to put it on a bracelet/necklace

Btw this is only for earrings with the thin wire end (like in the first picture), you can do this with bracelets and necklaces and it dosent matter what the necklace/bracelet is made of. First, if there is a little plastic thing on the wire backing then take it off. (Optional) If you have any beads then you can put them through the wire backing as a little detail. Put the wire backing in/on the necklace/bracelet (if it’s a chain then insert the wire into one of the chains, if the chain loops are too small/it isn’t a chain then just hang the looped part onto the necklace/bracelet. Then, use pliers to bend the wire backing into a loop (like in the second picture), some wire backings are definitely harder to bend then others (I lost one of the little things on the middle earring while trying to bend it because it was too hard). Make sure to bend it not like I did where there is excess on the back, either cut the excess of if you can or bend it to where the end is flat and touching the other side instead of being overlayed on top.