Small bracelet/necklace tip

If you have a bracelet or a necklace that has a clasp that you don’t like then use some moldable wire (I like to use 24 gauge but I’ve used 18 before and that’s fine as well) size the wire to what you want it to be (if you want it longer then cut off as long of a piece as you want it to be, if you want it smaller then use the loops on the side to use the wire for instead of the two very end loops and if you like the size how it is then a small amount of wire is fine) then at one of the ends of the wire, loop it into the clasp with pliers and make sure the clasp is stuck in that wire loop and use the other end of the wire to loop it into the loops on the other side and whether you want to loop it into the very last loop or a few loops next to it is your choice with the sizing. Then cut off any excess wire poking out of the wire loops with wire cutters so it won’t poke you and make sure to flatten the wire loop with pliers also to make sure that it won’t poke you. I’ve done this with necklaces but not bracelets but I would assume it would work the same since a bracelet is just a necklace for your arms.