Instructions for dangler assembly

Pictures and instructions for putting together the Shadow Milk Cookie dangler I made (and any others similar to it in the future) https://kandipad.com/pattern/shadow-milk-cookie-dangle-doll-6702551 1. Use hot glue to attach skewers to the perler pieces, there should be 3 on the bottom of the head to attach limbs and 1 at the top for it to dangle from. Be generous with your glue. 2. Slip the arms onto the left and right skewers through the holes modeled into them. 3. Once the arms are on, slip the body piece onto the center skewer. If the body piece is too big to dangle between the two skewers, glue it to them, as in this case it is meant to be stationary. 4. Attach 2 more skewers, this time to the back of the body piece. If you wish, you could do this before the body piece is attached. 5. Slip the legs onto the skewers you just attached to the body piece. 6. If the pattern has 1 tail piece, slip it onto the center skewer. If it has 2, slip each one onto the left and right skewers through. 7. At this point, your pieces should be attached in this order from front to back: head, arms, body, legs, tail(s). Ensure this order is correct before proceeding, use the attached pictures for reference if necessary. 8. Cut holes in a few small pieces of cardboard, just big enough for the skewers to fit through. Important note: make sure the pieces are cardboard you are using are bigger than the perler piece's holes, otherwise they’ll just slip off. 9. Slip the cardboard pieces onto the skewers the same way you did the perler pieces, but this time glue them to the skewers. Be sure to leave a bit of space for the perler pieces to move around. 10. Allow all glue to fully dry before attempting to dangle.