youll need maybe nine beads a flat iron parchment paper some patience hopefully this is helpful i make a lot of these and theyre pretty kewl
Step 1
heat up your flat iron to one of the higher settings
Step 2
put parchment paper on the heating parts (im not using any bc im too lazy to grab it) depending on your flat iron you can also skip this step but if you do take a piece and fold it over so the beads will sit between the parchment and the iron
Step 3
set them up on the iron like this use pliers, scissors, or VERY CAREFULLY your fingers (please dont get injured)
Step 4
flatten like this
Step 5
then use scissors or pliers to take it off when it looks like this CAUTION ITS EXTREMELY HOT
Step 6
then CAREFULLY mold it to your finger size THEN YOURE FINISHED!!
Step 7
additional steps: if this happens you need to try to remove the majority of the beads and then use the back of a bobby pin to remove the excess whilst its still warm
Step 8
try to roll it off with the bobby pin
Step 9
put a piece of paper between the iron and pull it out to remove the excess plastic repeat this untill the blade is clean
OKAYYYY ENJOY YOUR RINGGGGG i hope this was helpful and you enjoy your ring!!!